Information Regarding CHECKWEIGHING... Remember - to check weigh
ALWAYS weigh your vehicle on a flat level surface, as inclines may affect the accuracy of the system
and alarm targets. If the vehicle is loaded from the rear with small loads GVW may not be accurate. Observe drive
axle weight to determine load as front axle may have a negative input until load is forward of the rear axles...
Ensure - steering wheels are straight; briefly release brakes to ensure suspension is free or fully
inflated. When you want to weigh, you need to weigh the vehicle the same way every time. To ensure calibration
accuracy it is recommended that the same weighbridge is used for empty and full weights. (This system is for guide use only).
Alternatively - refer to the Downloads Section included on this page for documentation
regarding Configuration & Calibration procedures...
|
